Sorry, this product is no longer available!
Finish Line Fiber Grip Carbon Fibre Assembly Gel 50ml is no longer available at Merlin Cycles. However you may find an alternative or updated product below.

This item was discontinued 17th June 2015.

If you require help finding an alternative to this product please contact customer services.

Code: QPFG0175
  • Eliminates the need to over-tighten clamps to achieve a tight, secure and safe fit
  • Over tightening can cause internal fractures and fatigue of carbon fibre parts resulting in permanent failure
  • Additionally inadequately tightened components can be hazardous if they move or slip suddenly whilst riding
  • Apply Fiber Grip in a thin film to all clamping areas of stems, handlebars, seat posts, and seat tubes
  • Tested and approved by leading carbon fibre component manufacturers
Please enter your e-mail address below then click Notify Me to be notified when this item comes back into stock. We will not use your e-mail address for any other purpose.
The following errors occurred:

Please correct the errors and try again


Shipping charges for this item to United States: $7.52

Spend $75.16 or over and get free shipping
$ 7.52
$ 15.03
General information about our shipping
This stuff is amazing; cured a slipping Thomson seatpost in a Ti frame. It really grips and you don't need to use much for it to work. I haven't tried reducing torque settings but there's so much grip in this stuff I'm sure you could. OK, it's expensive but you aren't going to be using much to make a significant difference.
Did the on alloy components too and I have used successfully to stop saddle slip and seatpost slip
Great product does what it says on the tin!! Used for my rockshox reverb so not to over tighten it.
As always great service from Merlin, The carbon fibre assembly gel is a must for carbon seatposts etc, my seatpost used to slip slightly even with the correct torque setting but after application no more problems!
Stopped my reverb seatpost slipping down into frame.
works just as well on an ali frame & rockshox reverb to keep the torque on the seatpost clamp nice and low yet stop the post slipping.. Helps your Reverb return nice and fast - just as Rockshox recommend... Hard to find this at the LBS or Online, thanks Merlin...
I've always used Finish Line products and been more than happy with how they perform, this Fiber Grip is no different. Used it on my Reverb post and it does what it says on the tin, it maintains grip with less pressure needed than before.
This product sorted my slipping rockshox reverb stealth from slipping down the seatube , great stuff.