Code: 765
Replacement Shimano Disc Hose Kits
- Genuine Shimano cuttable hose kits.
- Fronts are 900mm or 1000mm long.
- Rears are 1700mm long.
- Includes all necessary fittings.
BarrieJust what i needed when changing the hose on my brakes, came with all the bits required, at the usual fantastic Merlin prices, and quick delivery
DimitriosReplaced my Shimano 785 XT brake line. Comes with everything necessary, minus the fluid, for a hose change.
BainesBought to replace an original XTR hose which was too short. The hose has the same right angle eyelet and looks/fits in an identical fashion to the XTR version it replaces on an 2011 XTR race brake setup
Aussie ScottHas all the parts required to replace old hose. Yellow cable holder works well when trying to put insert into hose. I used some vice grips to hold hose in place with yellow holders, then tapped insert in with a soft rubber mallet. Easy as.
Mr FletcherGreat for the job intended. I replaced SLX Calipers with 2013 model which require these hoses with the banjo fitting.
Mr JacksonGreat replacement, easy to install. Cheaper and better than aftermarket alternatives, like Jagwire.
Mr PikesleyGreat product, and a superb service as always.
Thanks keep up the good work.
Mr SampsonDoes what it is ment to do and not that expensive.
Mr SHERIDANBought the front kit to replace my Shimano SLX front brake hose. It was different to what was on the picture. Only one oilve and a different connection at the other end. I found out it was for an XTR brake. This wasn't clear on Merlin's website. I had to order another olive seperate.
Mr GouldIf you run dual crown forks youre going to need a rear hose up front.
Other than that they're perfect!!
Get one of these to bleed em though:
http://bit.ly/NLGDGM